Seleziona il tipo di ricerca:

Torna alla pagina precedente TORNA CATALOGO / ACCESSORI RC / RADIOCOMANDI / 15 TELEMETRIA / GRA33610

Articolo : GRA33610 Disponibilità :  Scarsa  PochiPz.
Prezzo : 50.50 €
Prezzo Web :    42.50 €
Quantità :
Il prodotto è stato inserito nel carrello!    


    GENERAL ENGINE MODULE 2-6S

    GENERAL ENGINE MODULE 2-6S   GENERAL ENGINE MODULE 2-6S   GENERAL ENGINE MODULE 2-6S
    GENERAL ENGINE MODULE 2-6S

    Fornitore

    General sensor for Graupner HoTT receiver and models with internal combustion or electric motor.

    Functions:

    2x temperature and voltage measurements with warning thresholds for minimum/maximum voltage and minimum/maximum temperature
    Single cell measurement with warning threshold for minimum voltage
    Voltage, current, and capacity measurement with warning thresholds for min/max voltage, max capacity, and max current
    Current limiting programmable
    Messurment of the current with shunt resistors 2x 1 mOhm parallel = 0.5 mOhm
    RPM measurement and warning threshold for min/max rpm
    Fuel measurement with warning threshold in 25% steps
    Warning time can be set to: OFF, 5, 10, 15, 20, 25, 30 seconds, always
    Warning repeat time can be set to: always, 1, 2, 3, 4, 5 minutes, once
    Important Note when using the modules 33600, 33601, 33610, 33611 and 33620:

    Do not carry out any programming work on the sensors while the model is flying, otherwise there is a real risk that your model will fly out of control while you are not concentrating on it!
    If your model is fitted with two or more receivers, it is absolutely essential that you do not carry out programming work during a flight, as this can alter the settings in the receivers to which no telemetry equipment is connected in the worst case this could result in the model crashing! For this reason always carry out programming on the ground, and check that only the receiver with connected sensors is powered on.

    Connections:

    2x temperature optionally selectable from 0 to either 120°C or 200°C and voltage measurement to 60 V DC
    1x rpm measurement up to 100 000 rpm with two-blade propeller
    1x speed controller/ servo input, 1x input rpm control, 1x speed controller / servo output for rpm control
    1x current, voltage, and capacity measurement up to 40A (60A for 1 s) and up to 30V
    1x single-cell monitoring for 2 - 6S lithium batteries (LiPo, LiIo, LiFe)
    1x receiver power supply input and output
    1x telemetry connection for receiver
    1x fuel sensor 0%/25%/50%/75%/100%

    Barcode 4013389456173


    Aggiungi l'articolo alla lista dei desideri!
     Articolo aggiunto alla tua lista dei desideri! 
    GENERAL ENGINE MODULE 2-6S
    Specification

    Dimensions (LxWxH) 41 (48) x 44 (56) x 16 mm
    Operating voltage 3,6 ... 8,4 V
    All-up weight, approx. 30 g



    Aggiungi l'articolo alla lista dei desideri!
     Articolo aggiunto alla tua lista dei desideri! 
    GENERAL ENGINE MODULE 2-6S

    Fornitore

    General sensor for Graupner HoTT receiver and models with internal combustion or electric motor.

    Functions:

    2x temperature and voltage measurements with warning thresholds for minimum/maximum voltage and minimum/maximum temperature
    Single cell measurement with warning threshold for minimum voltage
    Voltage, current, and capacity measurement with warning thresholds for min/max voltage, max capacity, and max current
    Current limiting programmable
    Messurment of the current with shunt resistors 2x 1 mOhm parallel = 0.5 mOhm
    RPM measurement and warning threshold for min/max rpm
    Fuel measurement with warning threshold in 25% steps
    Warning time can be set to: OFF, 5, 10, 15, 20, 25, 30 seconds, always
    Warning repeat time can be set to: always, 1, 2, 3, 4, 5 minutes, once
    Important Note when using the modules 33600, 33601, 33610, 33611 and 33620:

    Do not carry out any programming work on the sensors while the model is flying, otherwise there is a real risk that your model will fly out of control while you are not concentrating on it!
    If your model is fitted with two or more receivers, it is absolutely essential that you do not carry out programming work during a flight, as this can alter the settings in the receivers to which no telemetry equipment is connected in the worst case this could result in the model crashing! For this reason always carry out programming on the ground, and check that only the receiver with connected sensors is powered on.

    Connections:

    2x temperature optionally selectable from 0 to either 120°C or 200°C and voltage measurement to 60 V DC
    1x rpm measurement up to 100 000 rpm with two-blade propeller
    1x speed controller/ servo input, 1x input rpm control, 1x speed controller / servo output for rpm control
    1x current, voltage, and capacity measurement up to 40A (60A for 1 s) and up to 30V
    1x single-cell monitoring for 2 - 6S lithium batteries (LiPo, LiIo, LiFe)
    1x receiver power supply input and output
    1x telemetry connection for receiver
    1x fuel sensor 0%/25%/50%/75%/100%

    Barcode 4013389456173


    Aggiungi l'articolo alla lista dei desideri!
     Articolo aggiunto alla tua lista dei desideri! 
I prezzi scontati sono validi solo per prenotazioni o acquisti On-Line

Note tecniche e descrizioni dei vari articoli sono pubblicati così come vengono forniti dal costruttore e/o distributore, immagini allegate comprese, e potrebbero contenere delle inesattezze o delle omissioni. Non ci assumiamo quindi alcuna responsabilità a riguardo.


Modellismo Gianni - Via Pier Vittorio Aldini n.41   Roma (Uscita G.R.A. Ciampino Zona Industriale)
Tel. 06/72673332 • Fax. 06/72677092 • P. IVA 04563861006 • Mail: info@modellismogianni.it © Modellismo Gianni 2007
NOTA: tutti i prodotti da Noi distribuiti recepiscono la DIRETTIVA R.&.T.T.E. 1999/5/CE DECRETO LEGISLATIVO 269/01
PAGAMENTI :     CONSEGNE IN 24/48 ORE :

 webmaster : Massimo Marra